Component - Plastics E222591 LEPCO ENGINEERING PLASTICS TECHNOLOGY CO LTD 8 GOLDEN 2ND RD, BAIMA ADMINISTRATIVE EST, NANCHENG DISTRICT, DONGGUAN GUANGDONG 523000 CNM290G33Min Thk(mm)0.81.63.0FlameClassHBHBHB Polyamide 66 (PA66), glass reinforced, furnished as pelletsRTIElec120120120RTIImp9595105RTIStr100110120ColorALLHWI5HAI444Comparative Tracking Index (CTI):0Dielectric Strength (kV/mm):-High-Voltage Arc Tracking Rate -(HVTR):Dimensional Stability (%):-Inclined Plane Tracking (IPT):-Volume Resistivity (10x ohm-cm) :-High Volt, Low Current Arc Resis (D495):-ANSI/UL 94 small-scale test data does not pertain to building materials, furnishings and related contents. ANSI/UL 94 small-scale test data is intended solely for determining the flammability of plastic materials used in the components and parts of end-product devices and appliances, where the acceptability of the combination is determined by UL.Report Date: 2002-02-27 Last Revised: 2006-02-27© 2013 UL LLC IEC and ISO Test MethodsThicknessTest NameFlammabilityTest MethodIEC 60695-11-10UnitsClass (color)Tested (mm)0.81.63.0Glow-Wire Flammability (GWFI)Glow-Wire Ignition (GWIT)IEC Comparative Tracking IndexIEC Ball PressureISO Heat Deflection (1.80 MPa)ISO Tensile StrengthISO Flexural StrengthISO Tensile ImpactISO Izod ImpactISO Charpy ImpactIEC 60695-2-12IEC 60695-2-13IEC 60112IEC 60695-10-2ISO 75-2ISO 527-2ISO 178ISO 8256ISO 180ISO 179-2© 2013 UL LLCCCVolts (Max)CCMPaMPakJ/m2ValueHB75 (ALL)HB75 (ALL)HB40 (ALL)--------------------kJ/m2kJ/m2 The materials covered in this database are incomplete in certain constructional features or restricted in performance capabilities and are intended for use as components of complete equipment submitted for investigation rather than for direct separate installation in the field. THE FINAL ACCEPTANCE OF THE COMPONENT IS DEPENDENT UPON ITS INSTALLATION AND USE IN COMPLETE PRODUCTS SUBMITTED TO UNDERWRITERS LABORATORIES. Notice of Disclaimer